Bilige Question

Going through the licensing process ? Have queries, comments, or do you need an answer to that obscure exam question ? This is the place to post.
Post Reply
Duckman
Bilge Dweller
Posts: 4
Joined: Sun Dec 23, 2007 1:40 am

Bilige Question

Post by Duckman »

Your bilige pump wont get suction. What could it be?

User avatar
JK
Enduring Contributor
Posts: 2979
Joined: Tue Sep 04, 2007 2:29 am
Currently located: East Coast, Canada

Post by JK »

Sucking air somewhere-valve open to empty tank or bilge well.
Pump needs to be overhauled.

User avatar
The Dieselduck
Administrator
Posts: 3514
Joined: Sun Jul 22, 2007 1:41 pm
Currently located: Nanaimo, British Columbia, Canada (West Coast of Canada)

In my limited experience...

Post by The Dieselduck »

In my experience the most common answer to this problems is a plugged strainer. This is usually in a tight spot below deck plates or just an ugly job so no one wants to do it, but there is a good chance thats it is plugged, and plugs itself very fast, so no one thinks the 2 minutes they used it will affect anything.

Apart from that you can rattle off a multitude of defective things from the obvious no power to the motor to the obscure leaking mechanical seal and in everything in between like check valves, piping issues, busted gauge, broken belt, broken shaft, etc etc.
Martin Leduc
Certified Marine Engineer and Webmaster
Martin's Marine Engineering Page
http://www.dieselduck.net

User avatar
D Winsor
Superintendent
Posts: 360
Joined: Thu Nov 22, 2007 8:23 am
Currently located: Dartmouth

Post by D Winsor »

Another possibility is a leaking gasket or a cracked cover on the bilge strainer itself

User avatar
Dieseldame
Engineering Mentor
Posts: 88
Joined: Sun Dec 23, 2007 9:56 am
Currently located: Nova Scotia / Caribbean

Bilge suction

Post by Dieseldame »

If you have a bilge manifold, you should check that as well. If there's a hole you might have suction issues.

DD

User avatar
carbob
Leak Patrol
Posts: 31
Joined: Tue Nov 13, 2007 5:41 am
Currently located: St. John's, NL

Bilige question.

Post by carbob »

If the pump is a reciprocating type, it could be that something is caught under one of the valves inside the pump, keeping it open.

Post Reply