Eccentric sheave drawing exam

Going through the licensing process ? Have queries, comments, or do you need an answer to that obscure exam question ? This is the place to post.
IGW
Bilge Dweller
Posts: 2
Joined: Fri Apr 25, 2008 7:28 pm
Currently located: BC Canada

Eccentric sheave drawing exam

Postby IGW » Fri Apr 25, 2008 7:35 pm

Has anyone had to do the eccentric sheave and strap drawing. I was not too sure of the materials for the sheave and strap. cast steel? Any info would be great!

User avatar
The Dieselduck
Administrator
Posts: 2683
Joined: Sun Jul 22, 2007 1:41 pm
Currently located: Nanaimo, British Columbia, Canada (West Coast of Canada)

Nope not me...

Postby The Dieselduck » Sat Apr 26, 2008 8:21 am

Well, I think you stomped me. I have never even heard of that. I had a look through the Reed's drawing book and there was no mention of it either. Did you get that question from the this site?
Martin Leduc
Certified Marine Engineer and Webmaster
Martin's Marine Engineering Page
http://www.dieselduck.net

IGW
Bilge Dweller
Posts: 2
Joined: Fri Apr 25, 2008 7:28 pm
Currently located: BC Canada

Postby IGW » Sun Apr 27, 2008 7:13 am

I got the question on Friday for my drawing exam, I found a similar drawing in Magibbons but there is no materials list. I was just trying to get an idea if I passed or not. Thanks anyways.


Return to “Training Room”

Who is online

Users browsing this forum: No registered users and 2 guests

 

 

cron