Shaft Alignment

A place to exchanges questions and ideas of a technical / procedural nature. Go ahead, try to stomp us !
Post Reply
User avatar
winhlaingoo
Bilge Dweller
Posts: 9
Joined: Mon Sep 24, 2007 7:04 pm
Currently located: Myanmar
Contact:

Shaft Alignment

Post by winhlaingoo »

Could anyone tell me the basics of shaft alignmet and how should I calculate it?
The more unmindful you are, the more confused you are.
User avatar
The Dieselduck
Administrator
Posts: 4131
Joined: Sun Jul 22, 2007 1:41 pm
Currently located: Nanaimo, British Columbia, Canada (West Coast of Canada)
Contact:

Shaft alignment

Post by The Dieselduck »

Hello WHO, and welcome.

The alignment is not so much a calculation but rather a procedure. Most of the stuff I have done (short shafting and small propulsion plants 0-5MW) is rather straightforward with either a dial indicator gauge measuring deviation at the face and periphery of the flange you are aligning to. On smaller boats you can get away with just a straight edge and some feeler gauges.

Both method's aim is to make sure the mating surfaces are fully flat or aligned before mating them with bolts. Usually you have to work your way forward from the propeller... ie. tail shaft, intermediate shaft, thrust shaft or gear box, and finally engine.

There is obviously much more trouble shooting to be done on larger shaft and I understand that the strain gauge method is the most reliable in determining problem areas, which manifest them shelve as vibration to us mere mortal.

For details and further considerations on the procedure, I dug into my bible ("Marine Engineering" by SNAME) and scanned some pages for you on Shaft Alignment. You can download it here (http://dieselduck.info/_bigbin/shaft%20alignment.pdf) for the time being.

Hope that helps,
Martin Leduc
Certified Marine Engineer and Webmaster
Martin's Marine Engineering Page
http://www.dieselduck.net
Post Reply