S.S. = Stainless Steel?
Wrong.
Welding on crane boom
- Merlyn
- Fleet Engineer
- Posts: 1024
- Joined: Wed Dec 25, 2013 7:19 am
- Currently located: South Coast UK
- Contact:
Re: Welding on crane boom
Remembering The Good Old days, when Chiefs stood watches and all Torque settings were F.T.
- Merlyn
- Fleet Engineer
- Posts: 1024
- Joined: Wed Dec 25, 2013 7:19 am
- Currently located: South Coast UK
- Contact:
Re: Welding on crane boom
No one heard of that superb carbon steel close tolerance polished to very tight tolerances special steel?
Hard almost like inlet/ exhaust valve stems.
Allways in 13 inch lengths. Can have the colours run off the end.
Been trying to figure out why 13 inches and not a foot since 1960 .
Although you can buy it in longer lengths the basic is still 13 inches. And why no centres?
Why?
SILVER STEEL.
Hard almost like inlet/ exhaust valve stems.
Allways in 13 inch lengths. Can have the colours run off the end.
Been trying to figure out why 13 inches and not a foot since 1960 .
Although you can buy it in longer lengths the basic is still 13 inches. And why no centres?
Why?
SILVER STEEL.
Remembering The Good Old days, when Chiefs stood watches and all Torque settings were F.T.