Measuring rudder pintle bearing clearances

A place to exchanges questions and ideas of a technical / procedural nature. Go ahead, try to stomp us !
Post Reply
Vegman
Deck Plate Wanderer
Posts: 27
Joined: Fri Jun 28, 2013 3:19 am

Measuring rudder pintle bearing clearances

Post by Vegman »

Has anyone done this job in dry dock?
We have a two pintle semi balanced rudder- I am working on some docking specs.
Is it generally considered acceptable to bend/squeeze the feeler gauges in through the limited gap between the rudder and the lower rudder horn (lower pintle) and between the rudder horn and hull (upper pintle) or is it necessary to open up the welded closing plate in order to get good access with your feeler gauges or even to pull out the rudder?

I have done it once before in a drydock but it was a bit of rushed job and the just took the clearances without dismantling anything- I was wondering if that is "normal" or "good" practice.

popeye62
Tanktop Cleaner
Posts: 10
Joined: Mon Nov 21, 2016 2:36 am
Currently located: London

Re: Measuring rudder pintle bearing clearances

Post by popeye62 »

Hi Vegman
I was watching this job recently in DD (single pintle, semi-balanced) and the welded cover (actually this was a bolted and jointed cover) was removed. It is much easier and accurate this way i.e. you can see that you are getting a true clearance and not measuring a 'lip' in the bush or liner if fitted.
Having said that, in-water surveys, including pintle measurements are accepted by class. I cannot find any class requirements that state that the cover must be removed.
Presumably you have previous measurements and rates of wear? Is it likely that the clearance will exceed the 6 mm limit and the bushes will have to be changed anyhow?

Post Reply