Explosion of windlass hydraulic motor

General maritime and engineering discussion occurs on this board. Feel free to post newsbits, comments, ask questions about maritime matters and post your opinions.
User avatar
JK
Enduring Contributor
Posts: 2676
Joined: Tue Sep 04, 2007 2:29 am
Currently located: East Coast, Canada

Explosion of windlass hydraulic motor

Postby JK » Tue Nov 24, 2015 6:18 am

While a Hong Kong registered bulk carrier was heaving up anchor, the hydraulic motor of
the anchor windlass exploded and killed a crew member. This Information Note draws
the attention of the shipowners, ship managers, ship operators, masters, officers, crew and
Classification Societies on the lessons learnt in the accident.

HK Hydraulic Motor.pdf
(50.05 KiB) Downloaded 136 times

User avatar
Big Pete
Engineering Mentor
Posts: 786
Joined: Fri Apr 24, 2009 11:18 pm
Currently located: Solihull, England

Re: Explosion of windlass hydraulic motor

Postby Big Pete » Tue Nov 24, 2015 9:38 am

No Relief valves??
It is always better to ask a stupid question than to do a stupid thing.

User avatar
Merlyn
Fleet Engineer
Posts: 747
Joined: Wed Dec 25, 2013 7:19 am
Currently located: South Coast UK

Re: Explosion of windlass hydraulic motor

Postby Merlyn » Wed Nov 25, 2015 12:20 am

My thoughts exactly .
Remembering The Good Old days, when Chiefs stood watches and all Torque settings were F.T.

User avatar
D Winsor
Superintendent
Posts: 325
Joined: Thu Nov 22, 2007 8:23 am
Currently located: Dartmouth

Re: Explosion of windlass hydraulic motor

Postby D Winsor » Wed Nov 25, 2015 4:54 am

The report is pretty vague on details and it makes me wonder if it wasn't the coupling that exploded and not the hydraulic motor itself.
If there were issues in the hydraulic system, it is possible that any kind of rendering relief valve fitted to protect the motor may have failed.
It is also possible that the slipping clutch designed to protect the motor (if fitted ) was seized or had been adjusted to a higher torque limit in order to force more power out of the motor. After few burned out motors and coupling failures while lifting anchors it became mandatory, as part of the planned maintenance program of one fleet I worked in, to verify that the clutch was set correctly. This became a bit of an issue on some older boats when it came time to finding the fulcrum arm and counter weight used to set the slipping torque on clutch, either they we painted or rusted to the bulkhead or missing all together.
Troubleshooting 101 "Don't over think it - K.I.S.S. it"

User avatar
The Dieselduck
Administrator
Posts: 2683
Joined: Sun Jul 22, 2007 1:41 pm
Currently located: Nanaimo, British Columbia, Canada (West Coast of Canada)

Re: Explosion of windlass hydraulic motor

Postby The Dieselduck » Wed Nov 25, 2015 3:43 pm

I guess thats why they call it a "note", instead of a report, pretty thin on details, and how we can prevent it in the future, but ok, points for effort.
Martin Leduc
Certified Marine Engineer and Webmaster
Martin's Marine Engineering Page
http://www.dieselduck.net


Return to “Crew Mess”

Who is online

Users browsing this forum: Merlyn and 2 guests