USS MILWAUKEE out of service

General maritime and engineering discussion occurs on this board. Feel free to post newsbits, comments, ask questions about maritime matters and post your opinions.
User avatar
JK
Enduring Contributor
Posts: 2676
Joined: Tue Sep 04, 2007 2:29 am
Currently located: East Coast, Canada

USS MILWAUKEE out of service

Postby JK » Thu Dec 17, 2015 7:14 am

This is a fun article. Who uses the word, adamantine in the real world?
This gear box sounds like a sophisticated piece of equipment that will be a continuing headache. Black and gold debris in two seperate filters is not a good scenario.
The ship will go over 45 knots. From Wiki:
USS Milwaukee was the first Freedom-class LCS to be fitted with cavitation performance waterjets. The jets create partial vacuums in liquid using an improved impeller blade design. Cavitation jets do not increase the ship's top speed, but deliver 10 percent greater fuel efficiency with less noise and vibration, reduced life-cycle costs, improved maintainability, increased availability, and potentially improved efficiency at lower speed



The Navy’s newest Littoral Combat Ship – USS Milwaukee (LCS-5) – could be sidelined for weeks to repair an engine casualty that occurred last week during an Atlantic Ocean transit.

Lockheed Martin and the service are currently working through the total scope of the repair package for the gearings that connect the ship’s main engines to its water jets and timelines are far from adamantine.

But according to an initial assessment of the damage obtained by USNI News, and two sources familiar with the extent of the repair requirements, that timeline could push the work well into the new year.

“All concerned agree this will be a lengthy process,” read the early assessment seen by USNI News.

Naval Surface Force Pacific did not give a time estimate for completion of the work but did say it appears the damage to Milwaukee is not a issue throughout the Freedom-class, said spokeswoman Lt. Rebecca Haggard.

The ship was towed about 40 nautical miles to Joint Expeditionary Base Little Creek-Fort Story. Once pier side, the service found significant amount of gold and black debris in both the port and starboard combining gear of the propulsion system.

The crew of the ship first noticed particulate last week when in transit from Halifax, Canada to Naval Station Mayport, Fla.

“The Milwaukee crew initially took action [Dec. 7] when they discovered very fine metallic debris in the port combining gear filter system. The crew cleaned the combining gear filters following established procedures, but locked the port shaft as a precautionary measure to prevent possible shaft damage,” read a statement from the service.
“[Dec. 10] evening, while conducting routine steering checks, the ship lost pressure in the starboard combining gear lube oil system. The casualty was due to similar metallic debris contamination of the filter.”

Navy Times broke the story for the propulsion failure last week and reported the ship’s crew was alerted by a computerized monitoring system to the propulsion trouble.

The following is a description from an American Gear Manufactures Association technical paper on Freedom-class propulsion system.

Four water jets are driven by two symmetrically arranged [Combined Diesel and Gas (CODAG)] systems, where the high speed combining gear and the low speed splitter gear are separately installed, linked by long intermediate shafts each. Gas turbines and diesel engines can be engaged separately in cruise or higher speed propulsion modes, or jointly drive the water jets achieving a top speed in excess of 40 knots in this CODAG mode. To match with different required water jet speeds, the diesel engine inputs are equipped with two gear stages where the adequate gear ratio is selected via a multi disc clutch engagement.



“Engineers cleaned out the metal filings from the lube oil filter and locked the port shaft as a precaution,” according to the paper’s Scoop Deck blog.
“In the early hours of Friday morning, the ship was conducting steering tests and lost lube oil pressure in the starboard combining gear due to the presence of the same metal filings in that filter.”

The pair of combining gear links the high RPM output of the ship’s two massive Rolls Royce MT-30 gas turbines with the lower RPM output of the two Colt-Pielstick diesel engines and then to the ship’s shafts that drive the water jets.

The Combined Diesel and Gas (CODAG) propulsion scheme allows the semi-planning mono-hull the power to achieve the speeds of up to 40 knots.

The ship, the third in the Freedom-class, commissioned into the service late last month.

http://news.usni.org/2015/12/14/littora ... last-weeks

User avatar
The Dieselduck
Administrator
Posts: 2681
Joined: Sun Jul 22, 2007 1:41 pm
Currently located: Nanaimo, British Columbia, Canada (West Coast of Canada)

Re: USS MILWAUKEE out of service

Postby The Dieselduck » Sat Dec 19, 2015 3:36 pm

Now we know why these bloody things cost such a huge fortune, they use gold in the transmission. Nothing but the most expensive for the US navy. Or is it that is could be copper mistaken for gold? Clutch discs?
Martin Leduc
Certified Marine Engineer and Webmaster
Martin's Marine Engineering Page
http://www.dieselduck.net

User avatar
Merlyn
Fleet Engineer
Posts: 745
Joined: Wed Dec 25, 2013 7:19 am
Currently located: South Coast UK

Re: USS MILWAUKEE out of service

Postby Merlyn » Sun Dec 20, 2015 12:53 am

Maybe they steamed over an old treasure laded Spanish flagship with hundreds of millions worth of gold on board and with the sea suction those things pull drew a few bars on board and the super efficient impeller mashed it all up and Via leaky O rings on an engine oil cooler entered the lub system? The only course they need to plot being a reciprocal one ie the snails trail.
Remembering The Good Old days, when Chiefs stood watches and all Torque settings were F.T.


Return to “Crew Mess”

Who is online

Users browsing this forum: No registered users and 1 guest