2nd Class Oral
Posted: Wed Oct 14, 2009 7:59 am
Hi, all.
i am looking for a detailed answer for crankcase inspection. been searching around, couldn't get good answer for this question.
answer i have gathered so far is :
prior doing this job, all safety(turning gear engage, enclosed space entry,etc) is done,
check guide shoe surface for burning mark
check marking on crankpin and crank web
check tie bolt tightness
check any metal particles on sump surface
check suction pipe of oil mist detector is cleared
check LO flow is continuos
any help? thanks in advance
i am looking for a detailed answer for crankcase inspection. been searching around, couldn't get good answer for this question.
answer i have gathered so far is :
prior doing this job, all safety(turning gear engage, enclosed space entry,etc) is done,
check guide shoe surface for burning mark
check marking on crankpin and crank web
check tie bolt tightness
check any metal particles on sump surface
check suction pipe of oil mist detector is cleared
check LO flow is continuos
any help? thanks in advance